Dulux Trade Hichem Epoxy Enamel

Size
Paint Calculator
This product is not for online sale and can only be purchased from selected stores.
Find a Store
Your Measurements:
Amount Needed:
For the best result we recommend to use {coatAmount} for {productTitle}
Key benefits
  • Cures to a hard film with good adhesion and abrasion resistance.
  • Good resistance to a wide range of chemicals and most solvents.
  • Suitable for surfaces that require frequent cleaning with solvents, detergents or alkaline cleaners.
  • Provides an economical alternative to tiling in bathrooms, showers, kitchens, toilets and low cost housing
  • The cured film is non-toxic.
Technical Information
  • Finish High Gloss
  • Coverage Approx 9m² per litre per coat
  • Drying Time 24 hours Pot Life to gelation Approx. 8 hours at 25°C
  • Recoatable 6 hours minimum; up to 7 days maximum
  • Thinning Dulux Trade Heavy Duty Thinners for spraying to maximum of 10% of product volume and should only be added after mixing the Curing Agent with the Base and stirred homogeneous with a flat paddle. Do not apply directly to bare metal surfaces.
  • Composition Solvent-based
Product Features
  • Diamond tough
  • Shock resistant

Product Description

Dulux Trade Hichem Epoxy Enamel is a high gloss epoxy enamel for interior industrial and home use (e.g. garage floors, etc.) Can be applied on walls, floors and suitably primed metal surfaces.

Application Description

Brush, roller or airless spray

Technical & Safety Documentation

For detailed safety information refer to Material Safety Data Sheet. Keep out of reach of children. Store away from direct sun, heat and severe cold, and avoid naked flames or sparks. Ensure good ventilation during application and drying. Flash Point 25ºC.

System information

Dulux Trade Heavy Duty Thinners for spraying to maximum of 10% of product volume and should only be added after mixing the Curing Agent with the Base and stirred homogeneous with a flat paddle.Do not apply directly to bare metal surfaces. Recommended for interior surfaces only, as the film will chalk on exterior exposure. Cure is slow at low temperatures; below 15°C it takes some days to reach handling and recoating hardness. The pot life is short above 35°C; shield pressure pots and fluid lines from direct sun. Equipment and brushes must be cleaned immediately. Heat resistant to + 120°C (continuous) although some yellowing occurs above 100°C.Not suitable for direct application to powdery or friable surfaces whether previously painted or not.

Tips & Advice

  • 1. Preparing the Surfaces
    Suitable for cement plaster, concrete and ferrous surfaces.
  • 2. Cleaning
    For clean up use DULUX TRADE HD THINNER.
Fetching the data, please wait...